Helpful Guide in removing Old Carpet from your Floor

A basic and common home improvement project is getting new wall to wall carpet installed in a bedroom, living room, hallway, and so on. Installing carpet is best left to the professionals; however you can save money by doing some preparation work yourself. But then, you must read carpet shampooer review to know the best choice when your new carpet needs some cleaning.

In order to install carpet, the installers will need a bare plywood floor to install the pad and carpet on top of. Your task will be to get done to that bare plywood floor the installers desire and you will save money by doing so yourself and you will get a chance to fix that nasty squeaks in the process of prepping your floor.

To begin, you will have to remove all of the furniture from the room receiving new carpet. Enlist the help of a friend for this. Once the furniture is removed, you will have to remove the old carpet. Take a utility knife and cut the carpet in 3 foot wide strips. Cut straight through the carpet and the pad. 3 foot wide strips will make removal easier and ensure that your garbage men will take the old carpet away.

Once you have cut the strips, move to a corner of the room. Take an awl or thin screwdriver and pierce it through the carpet. This will aid in lifting the carpet off of the pad. Once you have a corner lifted, pull up the carpet with a firm motion. It will be held down by tack strips and will require force to remove. Once the carpet is free from the tack strips, roll it up and duct tape it to keep it from unrolling. Repeat this process until all of the old carpet is removed.

Now you will see the old padding. The pad is held down by thousands of staples. Begin by ripping all of the padding up, rolling it up, and taping it for easier disposal. Some staples will come up with the padding, most will stay in the plywood. You have two options for dealing with the staples left behind. You can take a hammer and pound them into the plywood, or you can use pliers and pull them out of the plywood. It is typically easier to pound the staples down, just make sure that you get all of them.

Now you will have to remove the old tack strips. Some installers may use these old tack strips to install the new carpet, however by removing them you do not give them that option and they must install new tack strips. The tack strips are held down by small nails spaced about 1 to 2 feet apart. To remove the tack strips, take a small pry bar and carefully hit it with a hammer until it in underneath the tack strip. Move down the length of the tack strip and repeat the process. This action will lift the tack strip out of the plywood. If the tack strip is still stuck, insert the pry bar underneath it and gently pry it loose.

Now everything is removed. The only thing left to do is to eliminate those pesky, squeaky floor boards. The squeaks occur when two pieces of wood move and rub against each other. This is a result of loose nail, or lack of nails. To remedy the problem, we will use 2 inch long drywall of deck screws. To begin, locate the squeak. Next located any nails in the plywood near the squeaky area. Hammer these nails back down. Use your cordless drill and drive a few screws in next to the nails in the area of the squeak. Follow the line that the nails are on. This will line up with the floor joists below and will give the screw something to grip to. Repeat this process until you floor is free of squeaks.

You have now completely prepped your floor for your new carpet. This entire process will only take a few hours to complete and will save you a significant amount of money. The money saved will vary depending upon installer, and what deals you receive for installation, however you can expect to save over $100 be during this process of prepping the floor yourself.

This task is simple and allows you to eliminate squeaks that can be irritating. Must carpet installers do not try to eliminate squeaks in the floor, but you will have the opportunity to do so by tackling this project.

The next time that you get new carpet, take on the task of prepping the room yourself. You will save money and you will know that the job was done right.

Releated